VEHICLE RECOVERY AND SPRING BRAKES Returning Vehicle to Service Spring Brakes—Manual Release You will have to add lubricant to prevent damage after your vehicle has been towed. The brakes can be released in this manner should the pressure in the air system not be enough to release them. This may occur in instances where the engine's air compressor is not able to get the system up to operating pressure. Recovering a vehicle requires that you release the parking brakes. There may be times when there is not enough air pressure to release the parking brakes. In such cases, the parking brakes (or Spring Brakes) can be manually released. 2 1.
Into the pinion cage, add 1 pint (.47 liter) of lubricant or into the interaxle differential, add 2 pints (.94 liter) of approved lubricant. WARNING! 2. After adding the specified type and amount of lubricant, drive the vehicle. It should be unloaded. Drive 1 to 2 miles (1.5 to 3 km) at a speed lower than 25 mph (40 km/h). This will thoroughly circulate the lubricant through the assembly. WARNING! Do not disassemble a spring brake chamber. These chambers con- tain a powerful spring that is com- pressed. Sudden release of this spring may result in death or per- sonal injury. Do not drive vehicle with malfunc- tioning brakes.
If one of the brake circuits should become inoperative, braking distances will increase sub- stantially and handling characteris- tics while braking will be affected. You could lose control of your vehi- cle or cause an accident. Have it towed to the nearest dealer or qual- ified repair facility for repair. Failure to comply may result in death, per- sonal injury, equipment or property damage. 2-20 Y53-6060-1C1 (03/17)