VEHICLE RECOVERY AND SPRING BRAKES pressure in the brake system, perform the following procedure: Do not operate a vehicle when the spring brakes have been manually released. Driving a vehicle after its spring brakes are manually released is extremely dangerous. The brakes may not function. Failure to comply may result in death, personal injury, equipment or property damage. WARNING! 4. Insert the release stud through the opening in the spring chamber where the cap was removed. Insert it into the pressure plate. Turn the release stud 1/4 turn clockwise in the pressure plate.
This secures the cross pin into the cross pin area of the pressure plate and locks it into the manual release position. 1. Remove the cap from the spring chamber. 2 2. Remove the release stud assembly from the side pocket, and remove the release nut and washer from the release stud. WARNING! Always secure the vehicle with wheel chocks, chains, or other safe means to prevent rolling be- fore manually releasing the spring brakes. Releasing the spring brakes on an unsecured vehicle could lead to an accident. The vehicle could roll, which may result in death, per- sonal injury, equipment or property damage. 5. Assemble the release stud washer and nut on the release stud. 3.
Slide out the release stud. To move a vehicle immobilized by the spring brakes due to loss of air (03/17) Y53-6060-1C1 2-21