Peterbilt Medium Duty — Sand, Mud, Snow and Ice

VEHICLE RECOVERY AND SPRING BRAKES Sand, Mud, Snow and Ice WARNING! 6. With a wrench, turn the release stud assembly nut until the compression spring is 90-95 percent caged. While doing this, check to make sure the push rod (adapter push rod or service push rod) is retracting. Do not over-torque the release stud assembly. (S-Cam type maximum: 50 lb-ft, Wedge type maximum: 30 lb-ft). The spring brake is now mechanically released. If the vehicle gets stuck in sand, mud, snow, or ice: Do not spin the wheels faster than 35 mph (55 km/h). Spinning a tire at speedometer readings faster than 35 mph (55 km/h) can be dangerous. Tires can explode from spinning too fast.

Under some conditions, a tire may be spinning at a speed twice that shown on the speedometer. Any resulting tire explosion could cause death or personal injury to a bystander or passenger, as well as extensive vehicle damage: includ- ing tire, transmission and/or rear axle malfunction. 2 Move the gearshift lever or selector from First to Reverse. Apply light pressure on the accelerator pedal while the transmission is in gear. Remove your foot from the accelerator while shifting. Do not race the engine. For best traction and safety, avoid spinning the wheels. Comply with the following instructions to avoid transmission damage: Always start vehicle in motion with the shift lever in first gear.

2-22 Y53-6060-1C1 (03/17)