Demontage und Montage, Motor komplett Disassembly and re-assembly of complete engine Dйmontage et remontage, moteur complet Desarmado y ensamblado, motor completo English Franзais Espacol Injection valves / injection lines Injecteurs / tuyauteries d’injection Inyectores / Tuberнas de inyecciyn 104. Slide new sealing ring to injection valve using some grease and insert injection valve. 104. Pousser un joint neuf avec un peu de graisse sur l’injecteur et insйrer l’injecteur. 104. Colocar el anillo de junta nuevo con un poco de grasa sobre el inyector e introducir йste. Note: The notch on the injection valve must face away from the tensioning claw. Nota:
Le lamage sur l’injecteur doit ktre dirigй vers le сфtй opposй а la patte. Nota: El rebaje existente en el inyector debe estar orientado hacia el lado opuesto a la garra. 105. Mount tensioning claw and slightly screw in. 105. Poser la patte et la serrer lйgиrement. 105. Colocar la garra de sujeciyn y enroscar el tornillo, dejбndolo suelto. 106. Fit new injection lines with sealing rubber elements. Fit cap screw finger-tight. 106. Monter des tuyauteries d’injection neuves avec un joint en caoutchouc. Serrer а la main l’йcrou-raccord. 106. Montar las tuberнas de inyecciyn nuevas con las obturaciones de goma. Enroscar la tuerca de uniyn con los dedos. Note: Re-bending is not allowed.
Injection lines must not be used twice. Nota: Un cintrage de correction n’est pas autorisй. Les tuyauteries d’injection ne doivent pas ktre utilisйes deux fois. Nota: No es admisible curvar ni reutilizar las tuberнas de inyecciyn. 4 107. Tighten bolts of claws. 107. Serrer les vis des pattes. 107. Apretar los tornillos en las garras. Specified tightening torque: 16 + 5 Nm Prescription de serrage: 16 + 5 Nm Prescripciyn de apriete: 16 + 5 Nm 4.00.43 © 2002 / 0312 0361