OPERATIONAL PERFORMANCE TEST / Adjustment PUMP LEARNING (Pump Regulator Pressure Learning) Detects electrical current and pressure, which control the pump regulator, of the pump control solenoid valve, and memorize in MC. (Refer to the T/M (SYSTEM) section.) Therefore, as difference between the signal to pump control solenoid valve from MC and the regulator pressure controlled by the pump control solenoid valve is adjusted, the pump swash angle is controlled correctly. Dr. ZX displays the pump status during the pump learning and can check if the learning has been done correctly. IMPORTANT: Perform the pump learning if the following work is done.
Replace the pump, pump regulator and pump control solenoid valve Replace MC IMPORTANT: After the learning, turn the learning switch to the OFF position. If the pump learning fails, the adjustment is not done. If the adjustment succeeds and the learning switch is turned by mistake, the learning may fail. Learning Start Condition MC, ECM: No breakdown, no failure Engine Control Dial: Fast idle Auto-Idle Switch: OFF Power Mode Switch: HP Mode Pressure Sensor: Output zero. (The control lever is in neutral.) Hydraulic Oil Temperature: 50 ± 5 ° C (122 ± 41 ° F) Pilot Shut-Off Lever: LOCK Position Learning Switch: OFF NOTE: Cancellation during learning:
When the learning switch is turned to the OFF position before finishing the learning, the adjustment is done according to the former learning result. T4-6-1