TROUBLESHOOTING / Troubleshooting A MC FAULT CODE 11989 IMPORTANT: In case switching the connector in solenoid valve and performing the diagnosing, check for continuity in the solenoid before switching. When the connector is switched and the engine starts with the solenoid shorted, normal solenoid valve and MC may be damaged. Pump control solenoid valve: 17.5 Ω at 20 ° C 4-spool solenoid valve unit: 18.5 Ω at 20 ° C regeneration). · Between terminal #A6 of connector MC-A in MC and terminal #2 of connector in solenoid valve unit (SC) (boom mode control regeneration).
Connector (Harness end of connector viewed from the open side) MC Connector MC-A Solenoid Valve Unit (SC) (Boom Mode Control) T1V1-05-04-003 T183-05-04-008 T5-6-84 Fault Code Trouble Cause 11989-3 Abnormal Feedback High Current of Solenoid Valve Unit (SC) (Boom Mode Control) Current: Higher than 920mA 11989-4 Abnormal Feedback Low Current of Solenoid Valve Unit (SC) (Boom Mode Control) Current: Less than 56 mA Switch connectors of solenoid valve unit (SC) Faulty solenoid valve unit YES (boom mode control) (SC) (boom mode and other solenoid control). YES valve unit (SF, SG or SI). Check if fault code in Faulty MC. switched solenoid valve NO unit is displayed.
Check for continuity in harness between MC and · After switching solenoid valve unit (SC) connectors, operate (boom mode control). combined operation of boom lower and bucket · Between terminal #A10 of or arm, and check by connector MC-A in MC and using Dr. ZX. terminal #1 of connector in Open circuit in harness. solenoid valve unit (SC) NO Open circuit in harness. NO #A6 #A10