TROUBLESHOOTING / Troubleshooting B E-9 Engine speed does not increase even if at- tachment is operated in attachment mode. Reference Page T5-6-28 In case trouble symptoms E-1 to E-11 are recog- nized, perform the troubleshooting of these trou- bles first. Even if the failure in pressure sensor (auxiliary) and power mode switch may have relevance to the malfunction of attachment operation speed increase control. However, if these sensor and switches fail, other operating functions will also be affected. Refer to the pages for Attachment Operation Speed Increase Control in the SYSTEM / Control System group in the T/M (Operational Principle). Check the wiring connections first.
T5-7-49 Trouble 11004 CAN Communication Error NO Normal (Set to Check if Engine Increase (+).) Speed Increase / Decrease of corre- NO sponding attach- ment is set to In- crease (+) as for Monitor attachment YES Faulty MC. Parameter Change control pilot in Dr. ZX. pressure. Check if Engine Speed Increase / Decrease of YES Check if pressure varies in response corresponding Faulty pressure sensor to lever stroke. attachment is set to NO (attachment). Decrease (-) as for · Monitor item: ATT Parameter Change in control pilot pressure Dr. ZX.
Normal (If P speed decrease is set, this YES control is inoperable.) NO Normal (Set to Increase (+).) Normal (If P speed decrease is set, this control is inoperable.)