TROUBLESHOOTING / Troubleshooting B OTHER SYSTEM TROUBLESHOOTING O-1 Wiper is inoperable or not retracted. Checking Instructions The wiper is driven by electric power routed via the relay circuit controlled by the monitor assem- bly. In case the wiper is inoperable, first check the wiper motor and links for any abnormality by us- ing an auxiliary electric power and the test har- ness. If the front window is open, the wiper does not closed. Check if wiper is oper- ated. Check if wiper relay is turned ON or OFF in response to INT. position of wiper switch. · Key switch: ON NO Open circuit in harness between wiper relay and monitor unit. · Key switch: ON · Wiper switch: INT Shut front window.
Disconnect wiper motor connector. Measure voltage between terminals B and L of har- ness end of connector. Check if voltage is 24 V. YES Open circuit in harness between window con- tact point and wiper motor. NO · Key switch: ON · Wiper switch: ON · Key switch: ON · Wiper switch: ON Open circuit in harness between wiper relay and window contact NO Window Contact Point (Cab Side) Connector Wiper Motor (Harness end) T1V1-05-07-005 Monitor Unit T183-05-05-001 T5-7-82 he front window is securely Switch wiper relay with NO other general relay. YES Faulty wiper relay. Disconnect monitor A connector in monitor unit. Connect terminal #A2 of harness end of connector to machine.
Disconnect wiper relay. NO Check for continuity be- tween terminal #2 of har- ness end of connector and machine. YES Faulty wiper motor. Open front window. Measure voltage be- tween terminals B and L of window contact point (cab side). YES Check if voltage is 24 V. INT. Position Set Time Slow 8 second Middle 6 second Fast 3 second B L S E #A2