hitachi — PREPARATION FOR PERFORMANCE TESTS

TROUBLESHOOTING / Troubleshooting B Greasing into Piping Greasing into piping between the distribution valve and lubricating points Piping between the distribution valve on boom and lubricating points: 1. Open discharge ports at top of the distribution valve on the boom to the atmosphere. (Do not attach the plugs.) 2. Grease into nipples at the centralized greasing block for boom. 3. Seal the ports with the plugs when grease comes out from discharge ports of the distribution valve on the boom. 4. Continue to grease into nipples at the centralized greasing block until lubricating points are filled fully with grease.

Piping between the distribution valve on main frame and boom cylinder bottom side: — Grease into discharge ports at the top of the distribution valve on the frame, and confirm that the boom cylinder bot- tom side is filled fully with grease. Piping between distribution valve on arm and lubricating points: 1. Open discharge ports at top of the distribution valve on the arm to the atmosphere. (Do not at- tach the plugs.) 2. Grease into nipples at the centralized greasing block for arm. 3. Seal the ports with the plugs when grease comes out from discharge ports of the distribution valve on arm. 4.

Continue to grease into nipples at the centralized greasing block until lubricating points are filled fully with grease. Greasing into supply piping (ranging from grease pump to the distribution valve on arm) for five min- utes. 1. Disconnect hose (2) from the grease pump and remove the plug from supply port (3) of the dis- tribution valve. 2. Attach a grease nipple to supply port (1) of the distribution valve on arm, and grease into the grease nipple. 3. Plug hose (2) and or supply port (3) whichever grease comes out first, continue to grease until grease comes out from the unplugged end or port. 4.

After confirming that grease comes out from the end or port, connect hose (2) to the grease pump and install the plug on supply port (3). Main Frame T17V-05-04-003 Greasing into Grease Pump 1. Confirm that a grease cartridge is provided inside the grease pump. 2. Remove an air vent screw from the grease pump. 3. Turn on the auto lubrication switch at the rear of cab. Turn on the key switch to start the grease pump. 4. Replace the air vent screw when grease comes out from the air vent port. (Normally, grease comes out within10 seconds.) 5. Turn off the key switch. T5-7-91 2 3 1 Ar Bo Ma 3