OPERATIONAL PERFORMANCE TEST / Excavator Test CONTROL LEVER OPERATING FORCE Summary: 1. Measure each lever operating force using a spring scale 2. Measure the maximum lever operating force at the grip center of each control lever. 3. Check the control lever condition. Preparation: Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). CAUTION: Prevent personal injury. Always make sure that the area is clear and that co-workers are out of the swing area before starting the measurement. Measurement: 1. Measure each control lever. 2. Measurement conditions are as below. T107-06-03-003 3.
Operate each boom (raise) arm and bucket lever to the fully and measure the maximum operating force for each with each actuator relieved. 4. Operate boom (lower) lever and measure the maximum operating force with the boom lower relieved by jacking up the machine in a safe area. 5. Operate swing lever and measure the maximum operating force with swing relieved after securing the front attachment to prevent swinging. 6. Lower the bucket to the ground to raise one track off the ground. Operate the travel lever to full stroke and measure the maximum operating force required. When finished, lower the track and then jack-up the other track. 7.
Perform the measurement three times and cal- culate the average values. Evaluation: Refer to the Performance Standard Table in Group T4-2. T107-06-03-004 T4-4-14 Engine Control Dial Power Mode Switch Work Mode Auto-Idle Switch Fast Idle HP Mode Digging Mode OFF