OPERATIONAL PERFORMANCE TEST / Excavator Test CONTROL LEVER STROKE Summary: 1. Check the lever stroke play and the lever operat- ing condition. Measure each lever stroke at the lever top using a ruler. 2. Measure the lever stroke at the grip center of each control lever. 3. In case lever stroke play is present in the neutral position, add half (1/2) the play present to both side lever strokes. NOTE: When the lever has play, take a half of this value and add it to the measured stroke. Preparation: Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). Measurement: 1. Stop the engine. 2. Measure each lever stroke at the lever top from neutral to the stroke end using a ruler. 3.
Perform the measurement three times and cal- culate the average values. Evaluation: Refer to the Performance Standard Table in Group T4-2. T107-06-03-005 T4-4-15