John Deere Z225, Z425, Z445 EZtrak — Stopping the Engine

OPERATING Right Turn Warm start: Set throttle lever to the run position. 6. Position choke knob: Cold start : Pull knob up and hold in the choke position. Warm start : If necessary, pull knob up and hold in choke position. IMPORTANT: Avoid damage! Starter may be damaged if starter is operated for more than 20 seconds at a time: C D • Wait two minutes before trying again if engine does not start. 7. Turn key switch to the start position. 8. After engine starts, release key switch to the run position, push choke knob down to off position, and move throttle to run. IMPORTANT: Avoid damage! Unnecessary engine idling may cause engine damage.

Excessive idling can cause engine overheating, carbon build-up, and poor performance. MX37902 9. Allow the engine to warm up for 20 seconds. 1. To turn slightly to the right, push left control lever (D) further forward than the right control lever (C). 10. Release park brake. Engaging Mower 11. Set both motion control levers to the neutral position. c CAUTION: Avoid injury! Clear mowing area of all bystanders when operating this machine. Thrown objects could cause serious injury or death. D Keep hands and feet away from blades and discharge opening. 1. Adjust mower to desired cutting height. Do not mow in reverse unless absolutely necessary. 2. Start engine. C 3. Release park brake. 4.

Move both motion control levers to the neutral position. 5. Set throttle lever to the RUN position. 6. Pull mower engagement switch up to engage mower. MX37903 NOTE: The travel speed and turn rate will vary with the amount that the control levers are moved. 2. To turn sharply to the right, push left control lever (D) forward and pull right control lever (C) rearward at the same time. 7. Push motion control levers forward slowly. Mow at a safe travel speed. Starting the Engine Stopping the Engine c CAUTION: Avoid injury! Engine exhaust fumes contain carbon monoxide and can cause serious illness or death. 1. Stop machine on a level surface, not on a slope. 2.

Push the mower engagement switch down to disengage mower. Do not run an engine in an enclosed area, such as a garage, even with doors or windows opened. 3. Move the motion control levers to the start/shutdown position. 4. Lock park brake. Move the machine to an outside area before running the engine. 5. Move throttle lever to the shutdown position. 1. Sit on the operator seat. 6. Allow the engine to cool down for 20 seconds. 2. Lock park brake. 7. Turn ignition key to STOP (off) position. 3. Push the mower engagement knob down to disengage the mower. 4. Set both motion control levers to the start/shutdown position. 5. Move throttle lever to set engine speed: Cold start:

Set throttle lever to the start position. Operating - 16