John Deere Z225, Z425, Z445 EZtrak — Checking For Plugging While Driving

OPERATING c CAUTION: Avoid injury! Children or bystanders may attempt to move or operate an unattended machine. NOTE: The bypass valves must be fully turned clockwise (closed) during normal vehicle operation. 1. Lock park brake. Always lock the park brake and remove the key before leaving the machine unattended. 2. Raise operator’s seat. 8. Remove key. Moving Machine by Hand A c CAUTION: Avoid injury! When the bypass valve is open, the machine will have unrestricted motion. • Do not open the bypass valve when the machine is stopped on an incline to prevent it from going downhill out of control. IMPORTANT: Avoid damage!

Transmission damage may occur if the machine is towed or moved incorrectly: • Move machine by hand only. • Do not use another vehicle to move machine. • Do not tow machine. MX37905 Z225 Model: 3. Turn bypass valves (A) on both sides of pump one full turn counterclockwise (open position). 4. Unlock park brake. 5. Push machine to desired location. Due to hydraulic system drag, machine will move slowly. IMPORTANT: Avoid damage! The bypass valves can be damaged if overtightened. Use care not to overtighten. NOTE: Bypass valves should be hand tightened only. 6. Turn both bypass valves one full turn clockwise (closed position) until tight. 7. Lock park brake.

A Unplugging Mower, Bagger, or Material Collection System c CAUTION: Avoid injury! Do not attempt to unplug attachment with machine running. • Rotating blades are dangerous. Shut off the engine and remove the key before getting off the seat to inspect the machine and attachment. MX37904 1. Pull out both bypass valve levers (A) at rear of machine. 2. Release park brake. • Thrown objects can cause serious injury. Make sure all machine parts are stopped before raising hopper top or removing chutes. 3. Push machine to desired location. IMPORTANT: Avoid damage!

The transmission might be damaged if the bypass valve lever is not pushed back to operating position before attempting to start the engine. Do not start or operate the machine with the bypass valve lever in the push position. Checking For Plugging While Driving Check the flow indicator on MCS chute (if equipped) periodically for any indication of loss of air flow. If grass builds up in front of mower discharge chute, check for plugged chute or problems with blower assembly (if equipped). 4. Push in both bypass valve levers. If there is a trail of clippings behind mower or clippings blow to the side, check for plugged chute, full collector bags, or problems with blower assembly.

Z425 and Z445 Models: When the machine needs to be moved without starting the engine, use the bypass valves: Operating - 17