SERVICE INTERVALS Removing Debris From Inspection Points: • Properly level mower deck for a smooth cut. c CAUTION: Avoid injury! Do not use hands or feet to clear plugged mower deck or blower assembly. Stored energy can cause blades to rotate. • Mow grass frequently. • Use a travel speed that fits the conditions: Mow tall or wet grass twice. Cut grass at half desired height – then cut at desired height. 1. Park machine safely. Wait for all moving parts to stop before getting off to inspect machine. Travel slow when mowing tall, thick or wet grass. Avoid damaging grass by slipping or skidding machine drive wheels. Practice smooth control lever movements. 2. Open hopper cover.
Check chute outlet. 3. Remove chute from mower deck or blower assembly. Check chute inlet. 4. Check under mower deck for debris. When performing sharp turns, do not allow inside machine drive wheel to stop and twist on grass. Transporting Machine on Trailer NOTE: Trailer capacity must exceed combined machine weight and attachment weight. (See Specifications section in operator’s manual). Service Intervals Servicing Your Machine Be sure trailer has all the necessary lights and signs required by law. IMPORTANT: Avoid damage! Operating in extreme conditions may require more frequent service intervals: c CAUTION: Avoid injury!
Use extra care when loading or unloading the machine onto a trailer or truck. Machine wheels can go off the ramp or trailer, causing the machine to tip over. • Engine components may become dirty or plugged when operating in extreme heat, dust or other severe conditions. • To load, back slowly and in a straight line. Keep wheels away from drop-offs and edges. • Engine oil can degrade if machine is operated constantly at slow or low engine speeds or for frequent short periods of time. Please use the following timetables to perform routine maintenance on your machine. • Do not use two separate loading ramps.
Use a full width loading ramp at least 30 cm (12 in.) wider than machine to keep castor wheels from going off the ramp edge. • Use a trailer with sides. Service Intervals Break-In after 8 Hours 1. Park trailer on level surface. • Change engine oil. 2. Raise mower deck before driving machine onto trailer. • Change engine filter (Z425 and Z445). Every 50 Hours or Annually • Lubricate mower deck spindles (Z425 and Z445). Every 100 Hours or Annually • Change engine oil. • Change engine filter (Z425 and Z445). • Replace spark plugs. • Replace air filter elements, both foam and paper. MX22500 • Replace fuel filter. 3. Back machine onto heavy-duty trailer with full-width ramp. • Check mower belt.
4. Lower mower deck completely. • Sharpen / Replace blades. • Clean underside of deck. 5. Lock park brake. 6. Turn off machine and remove key. • Check tire pressure. 7. Fasten machine at the axle or frame to trailer with heavy-duty straps, chains, or cables. Both front and rear straps must be directed down and outward from machine. • Clean engine cooling fins. Every 200 Hours Mowing Tips • Check / adjust engine valve clearance. See your John Deere dealer for this service. • Mow grass with throttle lever in the full fast / mow position. • Mow grass when it is dry. • Keep mower deck and discharge chute clean. • Mow with sharp blades. Service Intervals - 18