SERVICE LUBRICATION 48 and 54 in. Mower Decks Service Lubrication Grease IMPORTANT: Avoid damage! Use recommended John Deere greases to avoid component failure and premature wear. B The recommended John Deere greases are effective within an average air temperature range of -29 to 135 degrees C (-20 to 275 degrees F). B If operating outside that temperature range, contact your Servicing dealer for a special-use grease. B The following greases are preferred: • John Deere Multi-Purpose SD Polyurea Grease • John Deere Multi-Purpose HD Lithium Complex Grease MX37888 If not using any of the preferred greases, be sure to use a general all- purpose grease with an NLGI grade No.2 rating.
• Lubricate three mower deck spindle grease fittings (B) with two pumps of grease at specified interval. Wet or high speed conditions may require use of a special-use grease. Contact your Servicing dealer for information. Lubricating Front Caster Spindles Lubricating Mower Deck Spindles c CAUTION: Avoid injury! To avoid injury, Do not lubricate machine while the engine is running. NOTE: Removal of belt shields is not necessary to lubricate the spindles. 1. Remove mower deck foot plate. 42 in. Mower Deck B A A A MX37795 • The two front caster wheel supports (A) utilize sealed bearings, which do not require lubrication. There are no grease fittings in the wheel supports.
• The caster wheel yoke spindle (B) should be lightly greased prior to assembly if the wheel unit is serviced, to prevent the spindle from seizing in the bearings. MX37890 • Lubricate two mower deck spindle grease fittings (A) with two pumps of grease at specified interval. Service Engine Engine Warranty Maintenance Statement Maintenance, repair, or replacement of the emission control devices and systems on this engine, which are being done at the customers expense, may be performed by any non-road engine repair establishment or individual. Warranty repairs must be performed by an authorized John Deere dealer. Service Lubrication - 19