John Deere Z225, Z425, Z445 EZtrak — Single cylinder Briggs and Stratton:

Service Engine - 21 SERVICE E NGINE 6. Check oil level on dipstick. Oil must be between ADD and FULL marks. 7. If oil level is low, add oil to bring oil level no higher than FULL mark on dipstick. Do not overfill. C B 8. Install and tighten dipstick. Changing Engine Oil and Filter IMPORTANT: Avoid damage! Operating in extreme conditions may require more frequent service intervals: • Engine components may become dirty or plugged when operating in extreme heat, dust or other severe conditions. • Engine oil can degrade if machine is operated constantly at slow D or low engine speeds or for frequent short periods of time. 1. Run engine to warm oil. 2. Park machine safely on level surface.

(See Parking Safely in the SAFETY section.) IMPORTANT: Avoid damage! Dirt and contamination can enter engine when checking oil level. Clean area around dipstick before loosening or removing. 3. Clean area around dipstick to prevent debris from falling into crankcase. Single cylinder Briggs and Stratton: MX38113 1. Put drain pan under hole (A) of drain valve (B), and remove drain cap (C). B 2. Install drain hose (D) onto end of drain valve. Loosen engine dipstick. Turn drain valve counterclockwise and pull outward to allow oil to drain completely. C 3. Push drain valve inward, and turn clockwise to tighten. Remove drain hose, and install drain cap. 4.

Add oil no higher than FULL mark on dipstick. Begin with approximate 1.2 L (1.25 qt). Do not overfill. A 5. Install and tighten dipstick. 6. Start and run engine at idle to check for leaks. Stop engine. Fix any MX37942 leaks before operating. 7. Check oil level. Add oil if necessary. C B D Clean area around dipstick to prevent debris from falling into crankcase. ngle cylinder Briggs and Stratton: 1. Put drai (C). B 2. Install d Turn drain completely C 3. Push dr hose, and 4. Add oil 1.2 L (1.25 A 5. Install a 6. Start an MX37942 leaks befo 7. Check o Put drai ). MX38113 n pan under hole (A) of drain valve (B), and remove drain cap rain hose (D) onto end of drain valve.

Loosen engine dipstick. valve counterclockwise and pull outward to allow oil to drain . ain valve inward, and turn clockwise to tighten. Remove drain install drain cap. no higher than FULL mark on dipstick. Begin with approximate qt). Do not overfill. nd tighten dipstick. d run engine at idle to check for leaks. Stop engine. Fix any re operating. il level. Add oil if necessary.