SERVICE ENGINE Twin cylinder Briggs and Stratton: 8. Add oil no higher than FULL mark on dipstick. Begin with approximately 1.6 L (1.75 qt). Do not overfill. 9. Install and tighten dipstick. D 10. Start and run engine at idle to check for leaks. Stop engine. Fix any leaks before operating. 11. Check oil level. Add oil if necessary. Twin cylinder Kawasaki: A C MX37943 A B C A C MX37910 1. Put drain pan under drain valve (A), and loosen drain valve to drain oil into drain pan. B 2. Loosen dipstick (B), and allow oil to drain completely. 3. Wipe dirt from around oil filter (C). Place a drain pan under oil filter, and remove old filter. MX38114 4.
Put a light coat of fresh, clean oil on the new filter gasket. 1. Raise seat, and put drain pan under drain valve (A). 5. Install replacement oil filter by turning oil filter to the right (clockwise) until the rubber gasket contacts filter base. Tighten filter an additional one- half turn. 2. Install drain hose (B) onto bottom end of drain valve. Loosen fitting (C) to drain oil into drain pan. 3. Loosen dipstick (D), and allow oil to drain completely. 6. Tighten oil drain valve (A). 7. Add oil no higher than FULL mark on dipstick. Begin with approximately 1.5 L (1.6 qt). Do not overfill. 8. Install and tighten dipstick. 9. Start and run engine at idle to check for leaks. Stop engine.
Fix any leaks before operating. 10. Check oil level. Add oil if necessary. Cleaning Air Intake Screen and Engine Fins E c CAUTION: Avoid injury! Compressed air can cause debris to fly a long distance. MX37939 • Clear work area of bystanders. • Wear eye protection when using compressed air for cleaning purposes. 4. Wipe dirt from around oil filter (E). Place a drain pan under oil filter, and remove old filter. 5. Put a light coat of fresh, clean oil on the new filter gasket. • Reduce compressed air pressure to 210 kPa (30 psi). 6. Install replacement oil filter by turning oil filter to the right (clockwise) until the rubber gasket contacts filter base.
Tighten filter an additional one- half turn. IMPORTANT: Avoid damage! An obstructed air intake screen can cause engine damage due to overheating. Keep air intake screen and other external surfaces of the engine, including cooling fins, clean at all times to allow adequate air intake. 7. Tighten oil drain fitting (C), and remove drain hose (B). 1. Park machine safely. (See Parking Safely in the SAFETY Section.) Service Engine - 22