SERVICE ENGINE IMPORTANT: Avoid damage! Dirt and debris can enter the engine through a damaged filter element: C • Do not wash paper element. • Do not attempt to clean paper element by tapping against another object. B • Do not use pressurized air to clean element. • Replace element only if it is very dirty, damaged or the seal is cracked. 7. Inspect the foam precleaner (E) without removing it. If the foam precleaner is dirty: D a.Remove it from the filter carefully. b.Wash precleaner in a solution of warm water and liquid detergent. c.Rinse precleaner thoroughly. Squeeze out excess water in a dry cloth until precleaner is completely dry. 8. Clean air cleaner housing carefully.
Prevent any dirt from falling into carburetor. 9. Install foam precleaner mesh side up. MX37945 10. Install cartridge. Make sure cartridge and seal are properly seated and sealing the carburetor air intake area. 5. Inspect the foam precleaner (B) without removing it. 6. If the foam precleaner is dirty: 11. Install air cleaner cover and tighten knobs. Do not overtighten. Remove the filter carefully. Checking and Cleaning Air Cleaner Elements (Twin Cylinder Kawasaki) Wash precleaner in a solution of warm water and liquid detergent. Rinse precleaner thoroughly. Squeeze out excess water in a dry cloth until precleaner is completely dry. 1.
Park machine safely (See Parking Safely in the SAFETY section). 2. Let engine cool. IMPORTANT: Avoid damage! Dirt and debris can enter the engine through a damaged filter element: 3. Clean dirt and debris from the air cleaner cover. • Do not wash paper element. • Do not attempt to clean paper element by tapping against another object. B A • Do not use pressurized air to clean element. • Replace element only if it is very dirty, damaged or the seal is cracked. 7. Remove foam precleaner (B), wing nuts (C), and paper element (D). Inspect paper element. 8. If the paper filter element is damaged or dirty, replace filter. 9.
Clean air cleaner base very carefully, preventing any dirt from falling into carburetor. MX37910 10. Install foam precleaner (B) onto paper filter element (D). Install paper element onto carburetor base, and secure with two wing nuts (C). Install air cleaner cover and tighten wing nuts. 4. Loosen two knobs (A) and remove cover (B). Checking Spark Plug c CAUTION: Avoid injury! Touching hot surfaces can burn skin. The engine, components, and fluids will be hot if the engine has been running. Allow the engine to cool before servicing or working near the engine and components. 1. Park machine safely (See Parking Safely in the SAFETY section). Service Engine - 24