John Deere Z225, Z425, Z445 EZtrak — Checking Transaxle Oil Level

SERVICE TRANSMISSION Service Transmission Checking Transmission (Z225) The Z225 transmission is a sealed component. No maintenance is required on this transmission. If you suspect any transmission problems, please contact your authorized dealer. A Transmission Oil (Z425 and Z445) NOTE: Machine is filled with John Deere Low Viscosity HY-GARD® (J20D) transmission oil at the factory. Do not mix oils. Use only Low Viscosity HY-GARD® (J20D) transmission oil. DO NOT use type “F” automatic transmission fluid. MX37908 IMPORTANT: Avoid damage!

Use John Deere Low Viscosity HY- GARD® (J20D) transmission oil to reduce transmission noise and to increase response time for the hydraulics and power steering. Picture Note: Single cylinder Briggs and Stratton shown. • Do not drain or change hydrostatic transmission fluid. A • See your John Deere dealer for service. John Deere Low Viscosity HY-GARD® (J20D) transmission oil is specially formulated to provide maximum protection against mechanical wear, corrosion, and foaming. It may be used in all operating temperatures. Checking Transaxle Oil Level (Z425 and Z445) NOTE: On Z225 models, the transaxle is a sealed component. No maintenance is required on this transaxle.

If you suspect any transmission problems, please contact your authorized dealer. 1. Park machine safely on a level surface. (See Parking Safely in the SAFETY section.) Picture Note: Twin cylinder Briggs and Stratton shown. MX37909 A MX37910 Picture Note: Twin cylinder Kawasaki shown. 5. Slide hose clamps on both sides of fuel filter (A) away from fuel filter ends using pliers. 6. Disconnect hoses from filter. IMPORTANT: Avoid damage! Incorrect installation of fuel filter may cause engine damage. Install the filter with the arrow pointing in the direction of fuel flow for proper operation. 4. Locate transaxle oil reservoir (A) at rear of machine. Reservoir is marked FULL (B). 7.

Connect hoses to new filter making sure the filter arrow is pointing in the direction of the fuel flow. 8. Install clamps and check for leaks. Service Transmission - 26 IMPORTANT: Avoid damage! Hot hydraulic oil will expand and show incorrect oil level. Check oil level: • When oil is cold. • With engine not running. 2. 3. Allow machine to cool. Raise operator’s seat. C A B MX37940