SERVICE TRANSMISSION IMPORTANT: Avoid damage! Contamination can damage the hydraulic system. Clean thoroughly around reservoir fill cap before opening. 5. If oil level is low, clean area around reservoir cap (C). 6. Remove cap. 7. Add John Deere Low Viscosity HY-GARD™ (J20D) until oil level is at FULL mark on reservoir. 8. Install cap. 9. Start engine. 10. Operate machine forward and in reverse several times. 11. Park machine safely on a level surface. (See Parking Safely in the SAFETY section.) B 12. Wait at least 3 minutes for hydraulic oil to cool. 13. Check oil level again. Add oil if necessary. Picture Note: View from rear of machine.
MX37944 Changing Transaxle Oil and Filter (Z425 and Z445) 3. Clean area around hydraulic oil filter (B). NOTE: Z225 model: The transaxle is a sealed component. No maintenance is required on this transaxle. If you suspect any transmission problems, please contact your authorized dealer. 4. Place drain pan with at least a 9.9 L (10.5 qt) capacity under hydraulic oil filter, turn filter counterclockwise to remove and allow oil to drain completely. 5. Apply a film of clean oil on gasket of new filter. Z425 and Z445 models: Changing transaxle oil and filter is not required as a regular service interval and should not be changed unless servicing other components. 6. Install filter.
Turn filter clockwise until gasket makes contact with the mounting surface. Tighten 1/2 to 3/4 turn after gasket contact. NOTE: Reservoir capacity is approximately 8.5 L (9 qt). Total system capacity with filter is approximately 9.9 L (10.5 qt). 1. Park machine safely on a level surface. (See Parking Safely in the SAFETY section.) 7. Fill oil reservoir with approximately 8.5 L (9 qt) of oil. 8. Install reservoir cap. 9. Start engine. 10. Move throttle lever to the 3/4 fast idle position. 11. Unlock park brake. 12. Run engine in full forward position for five minutes and then cycle motion control levers forward and rearward several times. Check for leaks around filter. 13. Stop the engine.
Check oil level in reservoir. Add oil as necessary. Checking and Adjusting Neutral Creep Check neutral creep with with engine running, motion control levers in the start/shutdown position, park brake off, and machine on level ground. If the machine creeps forward or reverse while motion control levers are in the start/shutdown position, adjust the motion control lever linkages: 1. Park machine safely. (See Parking Safely in the SAFETY section.) 2. Raise seat. 2. Raise operator’s seat, and clean area around reservoir cap (A). Remove cap. Service Transmission - 27 IMPORTANT: Avoid damage! Contamination can damage the hydraulic system. Clean thoroughly around reservoir fill cap before opening.
MPORTANT: Avoid damage! Contamination can damage the ydraulic system. Clean thoroughly around reservoir fill cap efore opening. A MX37940