SERVICE TRANSMISSION C E B D MX38109 A Picture Note: Z225 shown. B MX37941 2. Adjust tracking: NOTE: Tracking bolts limit top forward speed. If both levers hit against the tracking bolts, turn both bolts counterclockwise equal amounts until only one bolt contacts the lever. This will achieve maximum forward speed. D E B If machine tracks to the left, turn tracking bolt (A) clockwise. If machine tracks to the right, turn tracking bolt (B) clockwise. C Cleaning Transaxle Cooling Fans (Z225) c CAUTION: Avoid injury! Compressed air can cause debris to fly a long distance. Picture Note: Z425 shown. Z445 similar. MX38110 • Clear work area of bystanders.
C • Wear eye protection when using compressed air for cleaning purposes. • Reduce compressed air pressure to 210 kPa (30 psi). D IMPORTANT: Avoid damage! To ensure proper cooling, keep the transaxle cooling fins and surrounding area clean at all times. Operating the transaxle with obstructed cooling fins could cause damage due to overheating. B A 1. Park machine safely. (See Parking Safely in the SAFETY section.) MX38118 3. Remove locking pin (A) on black yoke end (B), then remove yoke end from arm (C). Turn black yoke end on rod (D) in (clockwise) to decrease forward creep and out (counterclockwise) to decrease reverse creep. Repeat procedure, as necessary, on opposite side (E).
Install yoke ends back onto arms and secure with locking pin. Picture Note: Closeup of Z445 shown. Adjusting Tracking If the machine does not track in a straight line while going in full forward position, adjust the tracking: 1. Park machine safely. (See Parking Safely in the SAFETY section.) Service Transmission - 28