SERVICE TRANSMISSION Checking and Replacing Transaxle Drive Belt (Z225) c CAUTION: Avoid injury! Entanglement in a belt or sheave can cause serious injury. Stop engine and wait for all moving parts to stop. C B D NOTE: The transmission drive belt is self-adjusted using a spring tensioner and does not require a tension adjustment. Checking Belt: 1. Park machine safely. (See Parking Safely in the SAFETY section.) E MX38116 2. Inspect drive belt (A) for excessive wear, damage or stretching while in position on the engine sheave, transmission sheaves, and drive belt tensioner sheave. Replacing Belt: 1. Disconnect electric clutch wiring connector (B) from main wiring harness connector (C). 2.
Remove clutch wiring harness from retaining clip (D), and lower harness and connector (C) through hole (E). c CAUTION: Avoid injury! Components are installed under spring tension. Wear eye protection and use proper tools when installing and removing components with spring tension. 3. Remove mower deck drive belt (F). (See Replacing Mower Deck Drive Belt in the SERVICE MOWER section.) 4. Remove drive belt (A) from engine sheave (G), transmission sheaves and idler sheave (H). To make removal and installation of the belt easier, carefully rotate the spring loaded idler (I) counterclockwise (J), and remove belt. 5.
Install belt onto engine sheave, transmission sheaves and idler sheave as shown by arrows. 6. Install mower deck drive belt. Service Transmission - 29 A A MX37947 Picture Note: View from rear of machine. 2. Clean transaxle fan fins (A) and around exterior of each fan with a rag, brush, or compressed air. G F H J A I