John Deere Z225, Z425, Z445 EZtrak — Removing Mower (42 Inch Mower)

SERVICE MOWER 7. Install electric clutch wiring harness back through frame hole and connect to main wiring harness. Secure harness onto frame with retaining clip. c CAUTION: Avoid injury! Components are installed under spring tension. Wear eye protection and use proper tools when installing and removing components with spring tension. Checking and Replacing Pump Drive Belt (Z425 and Z445) 3. Remove mower deck drive belt (F). (See Replacing Mower Deck Drive Belt in the SERVICE MOWER section.) c CAUTION: Avoid injury! Entanglement in a belt or sheave can cause serious injury. Stop engine and wait for all moving parts to stop. 4. Remove drive belt (A) from drive sheaves and idler sheave.

To make removal and installation of the belt easier, carefully rotate the spring loaded idler (G) clockwise (H), and remove belt. NOTE: The transmission drive belt is self-adjusted using a spring tensioner and does not require a tension adjustment. 5. Install drive belt onto drive sheaves and idler sheave as shown. 6. Install mower deck drive belt. Checking Belt: 7. Install electric clutch wiring harness back through frame hole and connect to main wiring harness. Secure harness onto frame with retaining clip. 1. Park machine safely. (See Parking Safely in the SAFETY section.) A G Service Mower Removing and Installing Mower Deck Foot Plate F c CAUTION: Avoid injury!

Always operate the mower with the foot plate installed. Operating with the foot plate removed can cause serious injury. H Removing Foot Plate 1. Park machine safely. (See Parking Safely in the SAFETY section.) Picture Note: View from rear of machine. MX37946 C B B A C D E MX38117 MX37794 2. Inspect belt (A) for excessive wear, damage or stretching while in position on the transmission sheave and drive belt tensioner sheave. 2. Remove bolts (A) and nuts. Replacing Belt: 3. Rotate foot plate up using finger pull (B). 4. Remove foot plate. 1. Disconnect electric clutch wiring connector (B) from main wiring harness connector (C). Installing Foot Plate 2.

Remove clutch wiring harness from retaining clip (D), and lower harness end through hole (E). 1. Place tabs (C) of foot plate into slots in frame. 2. Lower foot plate. 3. Install bolts (A) and nuts. Removing Mower (42 Inch Mower) 1. Park machine safely. (See Parking Safely in the SAFETY section.) Service Mower - 30