SERVICE MOWER sheaves. 8. Install foot plate. Installing Mower (48 and 54 Inch Mowers) 1. Park machine safely. (See Parking Safely in the SAFETY section.) 2. Allow engine and muffler to cool completely. c CAUTION: Avoid injury! Rotating blades are dangerous. Before adjusting or servicing mower: • Disconnect spark plug wire(s) or battery negative (-) cable to prevent engine from starting accidently. • Always wear gloves when handling mower blades or working near blades. 3. Raise mower lift lever fully upward into transport lock position. 4. Slide mower deck under machine. A MX37891 5. Lower mower lift lever, and install pin and spring clip (A) onto each side of rear mower bracket.
D B F F C E 6. Install front draft rod (B) onto mower deck bracket (C) and onto draft bracket (D). Secure stud ends (E) with locking clip (F). MX37887 Install belt onto engine sheave. Install 3/8-inch ratchet onto square hole (E) in tension arm and rotate counterclockwise to release tension on belt, while installing mower belt onto left spindle sheave (F). Make sure belt is properly seated on all Service Mower - 33 SERVI C 5. of 6. de ). A MX37773 Lower mower lift lever, and install pin and spring clip (A) onto each si rear mower bracket. C D B MX37774 Install stud (B) onto front draft bracket (C). Secure with locking clip (D c CAUTION: Avoid injury!
Component is spring-assisted and under tension. Injury can occur if spring-assisted component is released suddenly. eleased suddenly. E F MX37890