SERVICE MOWER E D D C MX37893 Loosen bolt (C) on belt guide. Loosen hardware on two sheaves (D), and remove belt from all sheaves. 5. Inspect belt for wear or damage; replace as necessary. 7. Connect mower drive belt: Install belt onto engine sheave. 6. Clean top surface of mower deck and sheaves. 7. Install belt on mower deck as shown. Install 3/8-inch ratchet onto square hole (G) in tension arm and rotate clockwise to release tension on belt, while installing mower belt onto center spindle sheave (H). Make sure belt is properly seated on all sheaves. 8. Install and tighten bolt (C) on belt guide. 8. Install foot plate. E Replacing Mower Drive Belt (42 Inch Mower) 1. Park machine safely.
(See Parking Safely in SAFETY section.) 2. Allow engine and muffler to cool completely. 3. Remove mower deck. 4. Remove drive belt: F G Picture Note: Shown without sheave for clarity only. MX38099 9. Make sure belt guide (E) is indexed properly into hole (F) on tension arm (G). 10. Tighten sheave hardware to 47 N•m (35 lb-ft). 11. Make sure belt is properly seated on all sheaves, and install belt shield. 12. Install mower deck. Replacing Mower Drive Belt (48 and 54 Inch Mowers) 1. Park machine safely. (See Parking Safely in SAFETY section.) 2. Allow engine and muffler to cool completely. 3. Remove mower deck. 4. Remove drive belt: Service Mower - 34 c CAUTION: Avoid injury!
Component is spring-assisted and under tension. Injury can occur if spring-assisted component is released suddenly. eleased suddenly. G H MX37889 Picture Note: 48 inch mower deck shown. c CAUTION: Avoid injury! Components are installed under spring tension. Wear eye protection and use proper tools when installing and removing components with spring tension. nstalling and removing components with spring tension. • B A A MX37892 Remove two bolts (A) and left belt cover (B).