John Deere Z225, Z425, Z445 EZtrak — Checking for Bent Mower Blades

SERVICE MOWER c CAUTION: Avoid injury! Components are installed under spring tension. Wear eye protection and use proper tools when installing and removing components with spring tension. F B A G H A MX38100 Picture Note: Shown without sheave for clarity only. 9. Make sure belt guide (F) is indexed properly into hole (G) on tension arm (H). MX37894 10. Tighten sheave nut (D) and bolt (E) to 47 N•m (35 lb-ft). Picture Note: 48 inch mower deck shown. 11. Make sure belt is properly seated on all sheaves, and install belt shields. Remove six bolts (A) and left and right belt covers (B). 12. Install mower deck. Checking for Bent Mower Blades c CAUTION: Avoid injury! Blades are sharp.

Always wear gloves when handling blades or working near blades. Replace blades if defective. Never straighten or weld them. 1. Park machine safely. (See Parking Safely in the SAFETY section.) 2. Raise mower deck to highest position to access blades. sheaves. 5. Inspect belt for wear or damage; replace as necessary. A 6. Clean top surface of mower deck and sheaves. 7. Install belt on mower deck as shown. Picture Note: Mower deck with side discharge used for illustration MX4897 8. Install and tighten bolt (C) on belt guide. 3. Measure distance (A) between blade tip and flat ground surface. 4. Rotate blade 180° and measure distance between other blade tip and flat ground surface. 5.

Install new blade if the difference between the two measurements is more than 3 mm (1/8 in.). 6. Repeat for all blades. Service Mower - 35 C E D Loosen bolt Loosen nut ( MX37895 (C) on belt guide. D) and bolt (E) on sheaves, and remove belt from all