SERVICE ELECTRICAL Servicing Mower Blades Installing Mower Blades c CAUTION: Avoid injury! Rotating blades are dangerous. Before adjusting or servicing mower: 42 Inch Mower deck: 1. Align the splined center hole in the blade with the splined spindle shaft (G) and put the blade onto the mower spindle shaft with cutting edge toward ground. • Disconnect spark plug wire(s) or battery negative (-) cable to prevent engine from starting accidently. 2. Install washer (B), with cupped side towards blade, and install nut (A) to secure blade onto splined spindle shaft. • Always wear gloves when handling mower blades or working near blades. 3.
Block mower blade with a piece of wood to prevent spinning and tighten nut to 68 N•m (50 lb-ft). Removing Mower Blades 48 Inch Mower deck: 1. Park machine safely. (See Parking Safely in the SAFETY section.) 2. Raise mower deck to gain access to mower blades. If necessary, remove mower deck. 1. Make sure deflector cup (H) is seated properly between mower spindle and blade. 2. Position mower blade (F) with cutting edge toward ground onto mower spindle. 3. Block mower blade with a piece of wood to prevent it from spinning. 4. Remove mower blade(s): 3. Install washer (E), with cupped side towards blade, and install bolt (D) to secure blade onto spindle shaft. 4.
Block mower blade with a piece of wood to prevent spinning and tighten bolt to 68 N•m (50 lb-ft). G C Service Electrical WARNING: Battery posts, terminals and related accessories contain lead and lead components, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling. B A Service the Battery Safely MX37886 Picture Note: 42 inch deck shown. 42 inch mower deck: Loosen and remove nut (A), washer (B), and blade (C). H F E c CAUTION: Avoid injury! The battery produces a flammable and explosive gas. The battery may explode: D • Do not smoke near battery. • Wear eye protection and gloves.
MX36300 • Do not allow direct metal contact across battery posts. 48 and 54 inch decks: Loosen and remove bolt (D), washer (E), and blade (F). Picture Note: 48 inch deck shown. • Remove negative cable first when disconnecting. 5. Inspect blades; sharpen, balance or replace blades as necessary. • Install negative cable last when connecting. Removing and Installing the Battery Removing 1. Park machine safely. (See Parking Safely in the SAFETY section.) Service Electrical - 36