SERVICE ELECTRICAL 4. Push red cover (B) away from positive (+) battery terminal and remove cable (C) from battery. c CAUTION: Avoid injury! The battery produces a flammable and explosive gas. The battery may explode: 5. Remove hold down strap (D). • Do not smoke or have open flame near battery. • Wear eye protection and gloves. • Do not jump start or charge a frozen battery. Warm battery to 16°C (60°F). • Do not connect the negative (-) booster cable to the negative (-) terminal of the discharged battery. Connect at a good ground location away from the discharged battery. F E C H E D F G MX38092 6. Lower seat slightly to gain clearance for battery removal.
Seat can be removed to have better access to the battery and make it easier to remove. To remove seat: Remove wiring harness connector (E) and harness plug (F) from seat. Remove retaining clip (G) and remove rod (H) holding seat to machine. Remove seat. B A A- Booster Battery M71044 7. Remove battery. B- Disabled Vehicle Battery Installing 1. Connect positive (+) booster cable to booster battery (A) positive (+) post (C). 1. Place battery into battery tray so battery posts are facing toward rear of machine. 2. Connect the other end of positive (+) booster cable to the disabled vehicle battery (B) positive (+) post (D). 2. Install hold down strap. 3.
Connect negative (–) booster cable to booster battery negative (–) post (E). 3. Connect positive (+) cable to battery first, then negative (-) cable. 4. Apply general purpose grease or silicone spray to terminal to help prevent corrosion. 5. Slide red cover over positive battery terminal. Service Electrical - 37 2. 3. Raise operator’s seat. 6. Install seat, if removed. 7. Install wiring harness connector and harness plug on seat, if removed. 8. Lower seat. Cleaning Battery and Terminals 1. Park machine safely. (See Parking Safely in the SAFETY section.) 2. Disconnect and remove battery. 3. Wash battery with solution of four tablespoons of baking soda to one gallon of water.
Be careful not to get the soda solution into the cells. 4. Rinse the battery with plain water and dry. 5. Clean terminals and battery cable ends with wire brush until bright. 6. Install battery. 7. Attach cables to battery terminals using washers and nuts. 8. Apply spray lubricant to terminal to prevent corrosion. Using Booster Battery D A C B MX37907 Disconnect negative (-) battery cable (A).