John Deere Z225, Z425, Z445 EZtrak — Using Proper Fuel

SERVICE MISCELLANEOUS IMPORTANT: Avoid damage! Electric charge from booster battery can damage machine components. Do not install negative booster cable to machine frame. Install only to the engine block. Install negative booster cable away from moving parts in the engine compartment, such as belts and fan blades. 4. Connect the other end (F) of negative (–) booster cable to a metal part of the disabled machine engine block away from battery. 5. Start the engine of the disabled machine and run machine for several minutes. 6. Carefully disconnect the booster cables in the exact reverse order: negative cable first and then the positive cable. D A C B Replacing Headlight Bulb (If Equipped) 1.

Park machine safely. (See Parking Safely in the SAFETY section.) MX37906 3. Pull blown fuse out of socket. Picture Note: Z225 shown. Fuse identification: A 4. Check metal strip in fuse window and discard fuse(s) if strip is broken. 5. Push new, correct amp, fuse into correct socket. 6. Lower operator’s seat. 2. Turn bulb socket (A) 1/4 turn counterclockwise to remove. MX37472 3. Replace defective bulb with a new bulb. Service Miscellaneous 4. Insert bulb socket into housing, push in and turn 1/4 turn clockwise to install. Using Proper Fuel Replacing Fuse Use regular grade unleaded fuel with an octane rating of 87 octane or higher.

Fuel blends containing up to 10% ethanol or up to 15% MTBE reformulated fuel are acceptable. Do not use fuel or additives containing methanol as engine damage can occur. 1. Park machine safely. (See Parking Safely in the SAFETY section.) 2. Raise operator’s seat. Always use fresh, clean fuel that is purchased in a quantity that can be used within approximately 30 days, or add fuel stabilizer. Fuel is blended to give best seasonal performance. To avoid engine performance problems such as hard starting or vapor lock, use in-season fuel. Use fuel during warm weather that was purchased during that season, and use fuel during cold weather that was purchased during that season.

Fuel can become stale in machines with engines that are used seasonally or infrequently during a season. Stale fuel can produce varnish and plug carburetor components which can affect engine performance. Keep fuel storage container tightly covered and in a cool area out of direct sunlight. Fuel can break down and degrade if not sealed properly or exposed to sun and heat. Condensation may collect in the fuel tank because of a variety of operating or environmental conditions and, over time, may affect your machine’s operation. Fill fuel tank at the end of daily use and store fuel in plastic containers to reduce condensation.

For best year-round performance and fuel-handling, add stabilizer to fuel Service Miscellaneous - 38 Position Circuit Fuse Size A Main Circuit 20 amp B Starter Circuit 20 amp C Key Switch/Fuel Solenoid 7.5 amp D Headlights (Optional) 7.5 amp