SERVICE MISCELLANEOUS immediately after fuel purchase. Such practice helps prevent engine performance problems and allows fuel storage in the machine all year without draining. NOTE: Refer to the SPECIFICATIONS section for tire pressures. 2. Check tire pressure with an accurate gauge. Filling Fuel Tank 3. Add or remove air, if necessary. c CAUTION: Avoid injury! Fuel vapors are explosive and flammable: Removing and Installing Wheel Assembly Removing 1. Park machine safely. (See Parking Safely in the Safety section.) • Shut engine off before filling fuel tank. c CAUTION: Avoid injury! The machine can fall or slip from an unsafe lifting device or supports. • Do not smoke while handling fuel.
• Keep fuel away from flames or sparks. • Fill fuel tank outdoors or in well ventilated area. • Use a safe lifting device rated for the load to be lifted. • Clean up spilled fuel immediately. • Lower machine onto jack stands or other stable supports and block wheels before servicing. • Use clean approved non-metal container to prevent static electric discharge. • Use clean approved plastic funnel without screen or filter to prevent static electric discharge. IMPORTANT: Avoid damage! Place jack stands under frame, not under transmission or engine, when raising or supporting machine. IMPORTANT: Avoid damage! Dirt and water in fuel can cause engine damage: 2.
Raise machine with a safe lifting device and lower machine onto jack • Clean dirt and debris from the fuel tank opening. • Use clean, fresh, stabilized fuel. • Fill the fuel tank at the end of each day’s operation to keep condensation out of the fuel tank. • Use a non-metallic funnel with a plastic mesh strainer when filling the fuel tank or container. Fill fuel tank at the end of each day’s operation to prevent condensation and freezing during cold weather. 1. Park machine safely. (See Parking Safely in the SAFETY section.) 2. Allow engine to cool. 3. Remove any trash from area around fuel tank cap. 4. Remove fuel tank cap slowly to allow any pressure built up in tank to escape. 5.
Fill fuel tank only to bottom of filler neck. 4. Remove the wheel assembly. 6. Install fuel tank cap. c CAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly: Checking Tire Pressure c CAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly: • Do not attempt to mount a tire without the proper equipment and experience to perform the job. 5. Take wheel assembly to an authorized service dealer for repairs. • Do not attempt to mount a tire without the proper equipment and experience to perform the job. Installing • Do not inflate the tires above the recommended pressure. 1.
Install wheel assembly with valve stem to the outside. • Do not weld or heat a wheel and tire assembly. Heat can cause an increase in air pressure resulting in an explosion. Welding can structurally weaken or deform the wheel. 2. Tighten wheel nuts evenly in alternating sequence until snug. 3. Lower machine completely to the ground. 4. Tighten wheel nuts to 102 N•m (75 lb-ft). • Do not stand in front or over the tire assembly when inflating. Use a clip-on chuck and extension hose long enough to allow you to stand to one side. Cleaning and Repairing Metal Surfaces Cleaning: 1. Check tires for damage. Follow automotive practices to care for your vehicle painted metal surfaces.
Use a high-quality automotive wax regularly to maintain the Service Miscellaneous - 39 or other stable supports. Block wheels remaining on the gr machine movement. A A MX2 ove the wheel nuts (A).