TROUBLESHOOTING Troubleshooting - 40 factory look of your vehicle’s painted surfaces. Repairing Minor Scratches (surface scratch): 1. Clean area to be repaired thoroughly. IMPORTANT: Avoid damage! Do not use rubbing compound on painted surfaces. 2. Use automotive polishing compound to remove surface scratches. 3. Apply wax to entire surface. Repairing Deep Scratches (bare metal or primer showing): 1. Clean area to be repaired with rubbing alcohol or mineral spirits. 2. Use paint stick with factory-matched colors available from your authorized dealer to fill scratches. Follow directions included on paint stick for use and for drying. 3.
Smooth out surface using an automotive polishing compound. Do not use power buffer. 4. Apply wax to surface. IF CHECK Engine Cranks But Will Not Start Spark plug wire is loose or disconnected. Improper fuel. Plugged fuel filter. Electrical problem - See Electrical Troubleshooting Section Engine Is Hard To Start Carburetor is not adjusted properly or dirty. Choke not fully closing. Plugged fuel filter. Faulty spark plug. Stale or improper fuel. Loose or corroded electrical connections. Engine oil viscosity. Engine Runs Unevenly Cooling fins plugged.
Troubleshooting Using Troubleshooting Chart If you are experiencing a problem that is not listed in this chart, see your authorized dealer for service. When you have checked all the possible causes listed and you are still experiencing the problem, see your authorized dealer. Engine IF CHECK Poor Engine Performance Dirt in fuel system or fuel is old. Replace fuel with fresh stabilized fuel. Obtain fuel from another supplier before suspecting machine problems.
Suppliers blend fuels differently and changing suppliers will generally solve any performance problems Fuel blended with alcohol or ether may contribute to performance problems by causing gum and varnish deposits, especially if fuel is stored for several weeks or more. Obtain fresh fuel. Engine Will Not Start - No Park brake not locked. Crank Motion control levers not in Start/ Shutdown position. Mower is engaged. Defective brake, mower engagement, or key switch. Electrical problem - See Electrical Troubleshooting Section Loose electrical connections. Choke or throttle cable sticking. Choke not fully open. Fuel line or fuel filter plugged. Stale or dirty fuel. Improper fuel.
Air cleaner element plugged. Engine Misses Under Load Faulty spark plug. Stale or dirty fuel. Plugged fuel filter. Engine Vapor Locks Fuel tank vent plugged. Dirt in fuel filter. Cooling fins plugged. Loose hose connection at fuel filter or fuel pump. Engine Overheats Engine air intake screen plugged. Cooling fins plugged. Engine oil low or too high. Engine operated too long at a slow idle speed. Engine Will Not Idle Spark plug not gapped correctly. Faulty spark plug. Operator raising off the seat. Engine Knocks Stale or low octane fuel. Engine overloaded. Low engine speed. Oil level low. Engine Stops Or Misses When Operating On Hillsides Fuel tank less than half full of fuel.
Operator raising off of the seat. Engine Backfires Faulty spark plug. Operator raising off of the seat. IF CHECK Poor Engine Performance Dirt in fuel system or fuel is old. Replace fuel with fresh stabilized fuel. Obtain fuel from another supplier before suspecting machine problems. Suppliers blend fuels differently and changing suppliers will generally solve any performance problems Fuel blended with alcohol or ether may contribute to performance problems by causing gum and varnish deposits, especially if fuel is stored for several weeks or more. Obtain fresh fuel. Engine Will Not Start - No Crank Park brake not locked. Motion control levers not in Start/ Shutdown position.
Mower is engaged. Defective brake, mower engagement, or key switch. Electrical problem - See Electrical Troubleshooting Section