OM3232 9/09 Operator Cab And Controls - Section 32 Page 32-23 The Orbcomm controller transmits data through antenna (1, Figure 32-11) mounted on top of the cab with magnetic mount (2, Figure 32-11). The antenna coaxial cable is routed through the cab to protect it from damage. If the antenna or coaxial cable is damaged, replace the part. FIGURE 32-12. INTERFACE MODULE (REAR WALL OF AUXILIARY CONTROL CABINET) 1. Interface Module 2. Green LED Light Basic Precautions Never disassemble, repair, or modify VHMS. This may cause failure or fire on the machine or this system. Do not touch the system when operating the machine. FIGURE 32-11. ORBCOMM ANTENNA 1. Orbcomm Antenna 2.
Magnetic Mount Do not pull on the wiring harnesses, connectors, or sensors of this system. This may cause short circuits or disconnections that lead to failure or fire on the machine or this system. Interface module (1, Figure 32-12) receives data from the sensors installed on the truck and sends this information to the VHMS controller. There is a small green LED light (2) on the face of the controller. When the key switch is ON, the light should be blinking. If the light is continuously illuminated, there is a problem in the controller. Do not get water, dirt, or oil on the system controllers. If there is any abnormality with VHMS, consult the servicing Komatsu distributor.
When a new interface module is installed on the truck, new software has to be installed inside the controller. IM diagnostic port (5, Figure 32-4) on the box behind the operator’s seat is used to connect the interface module to a computer for installing software.