Komatsu — WHEEL MOTOR SERVICE

OM4057 10/09 Lubrication and Service - Section 40 Page 40-1 LUBRICATION AND SERVICE GENERAL HYDRAULIC TANK SERVICE Recommended preventive maintenance will contribute to the long life and dependability of the truck and its components. The use of proper lubricants and the performance of checks and adjustments at the recommended intervals is most important. There are two sight gauges on the side of the hydraulic tank. With the engine stopped, key switch OFF, hydraulic system depressurized, and dump body down, the oil level should be visible in the center of the top sight gauge. If it is not, follow the instructions below for adding oil.

Lubrication requirements are referenced to the lube key found in the Lubrication Chart (page 2-5). For detailed service requirements for specific components, refer to the shop manual section for that component. Adding Hydraulic Oil NOTE: To lessen the chances of system contamination, keep the hydraulic system open to the atmosphere only as long as absolutely necessary. Refer to the manufacturer's service manual when servicing any components of the propulsion system. Service the tank with clean Type C-4 hydraulic oil only. All oil being put into the hydraulic tank should be filtered through 3 micron filters.

Refer to engine manufacturer's service manual when servicing the engine or any of its components. 1. With the engine stopped, key switch OFF, hydraulic system depressurized, and dump body down, check whether the oil level is visible in the center of the top sight gauge. The service intervals presented here are in hours of operation. These intervals are recommended in place of an oil analysis program which may determine different intervals. However, if the truck is being operated under extreme conditions, some or all of the intervals may need to be shortened and the service should be performed more frequently. 2.

If the oil level is not visible in the center of the top sight gauge, remove the tank fill cap and add clean, filtered C-4 hydraulic oil (Lubrication Chart, Lube Key “B”) until the oil level is visible in the center of the top sight gauge. The truck is equipped with an automatic lubrication system. The initial setup for this system provides for nominal amounts of lubricant to be delivered to each serviced point. The lubrication injectors can be adjusted to vary the amount of lubricant delivered. In addition, the timer for lubrication intervals is normally adjustable. For adjustments to these devices, refer to Section 42, Automatic Lubrication System. 3. Replace the tank fill cap. 4.

Start the engine. Raise and lower the dump body three times. 5. Repeat Steps 1 through 4 until the oil level is maintained in the center of the top sight gauge with the engine stopped, dump body down, and hydraulic system depressurized. 860E-1K SERVICE CAPACITIES Do not overfill the hydraulic tank! WHEEL MOTOR SERVICE Due to differences in gear ratio and component evolution/design, wheel motor service intervals may be unit number and/or mine specific. Because of the wide variety of factors involved, it is necessary to consult your area Komatsu representative for all wheel motor service intervals and instructions.

General intervals for oil service and sampling are listed in the interval charts. Component/System Liters U.S. Gallons Crankcase (including 4 oil filters) Komatsu SSDA16V160 Engine 280 74 Cooling System Komatsu SSDA16V160 Engine 473 125 Hydraulic System Refer to “Hydraulic Tank Service” 1609 425 Wheel Motors (each side) 121 32 Fuel Tank (Diesel fuel only) 4542 1200 Inverter Cabinet Cooling System 25 6.5