Komatsu — Reserve Oil Tank Filling Procedure (Remote Fill)

Lubrication and Service - Section 40 10/09 OM4057 Page 40-2 COOLING SYSTEM SERVICE RESERVE ENGINE OIL SYSTEM Check the coolant level sight gauge. If coolant cannot be seen in the sight gauge, add coolant to the system before truck operation. Refer to the procedure below for the proper filling procedure. The reserve engine oil system is designed to add more oil capacity to the engine to reduce the frequent servicing of the engine oil. The engine oil level must still be checked every shift by using the dipstick. If the engine oil level is not correct, check for proper operation of the reserve engine oil system. Never add oil to the engine unless it has been drained.

Radiator Filling Procedure If the engine oil has been drained from the oil pan, new oil must be added to the engine oil pan before starting. Do not use the oil in the reserve tank to fill an empty engine with oil. After an oil change, both the engine and reserve tank must be full of oil before starting the engine. The cooling system is pressurized due to thermal expansion of coolant. Do not remove the radiator cap while the engine and coolant are hot. Severe burns may result. 1. With the engine and coolant at ambient temperature, remove the radiator cap. Reserve Oil Tank Filling Procedure (Remote Fill) NOTE:

If coolant is added using the Wiggins quick fill system, the radiator cap must be removed before adding coolant. 1. Connect the pressure supply hose from the new oil supply to the quick coupler on the truck. Open the valve on the supply hose to apply pressure. 2. Fill the radiator with the proper coolant mixture (as specified by the engine manufacturer) until coolant is visible in the sight gauge. 2. On remote control box (1, Figure 40-1), pull out on power switch (2) to turn on the system. 3. Install the radiator cap. 3. Push start switch (3). VALVE OPEN light (5) should illuminate and the filling process will begin. 4. Run the engine for 5 minutes, then check the coolant level. 5.

If coolant is not visible in the sight gauge, repeat Steps 1 through 4. Any excess coolant will be discharged through the vent hose after the engine reaches normal operating temperature. 4. When the tank is full, the VALVE OPEN light will turn off and FULL light (4) will illuminate. 5. Close the oil supply valve in the fill hose. 6. Press start switch (3) for a couple of seconds. 7. Disconnect the new oil supply hose. NOTE: Engine coolant must always be visible in the sight gauge before truck operation. 8. Push power switch (2) to turn off the system. 1. Remote Control Box 2. Power Switch 3. Start Switch FIGURE 40-1. CONTROL PANEL 4. FULL Light 5.

VALVE OPEN Light COOLING SYSTEM ANTI-FREEZE RECOMMENDATIONS (Ethylene Glycol Permanent Type Anti-Freeze) Percentage of Anti-Freeze Protection To: 10 -5° C (23° F) 20 -9° C (16° F) 25 -11° C (11° F) 30 -16° C (4° F) 35 -19° C (-3° F) 40 -24° C (-12° F) 45 -30° C (-23° F) 50 -36° C (-34° F) 55 -44° C (-48° F) 60 -52° C (-62° F) Use only anti-freeze that is compatible with the engine (as specified by engine manufacturer).