Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

Lubrication and Service - Section 40 10/09 OM4057 Page 40-8 All 10 Hour (Daily) Inspections should also be performed at this time. 250 HOUR LUBRICATION AND MAINTENANCE CHECKS NOTE: “Lube Key” references are to the Lubrication Chart on page 40-3. *1. 2. 3. 4. * This is required only after the initial 250 hours of operation , such as the commissioning of a new truck or after installing a new or rebuilt component. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS HYDRAULIC SYSTEM FILTERS - Replace the filter elements.

Check the oil level. Add oil as necessary. (Lube Key “B”) ENGINE - 1. Change the engine oil. Refer to the engine operation and maintenance manual for engine oil specifications. (Lube Key “A”) NOTE: If the engine is equipped with the Centinel™ oil system and/or the Eliminator™ filter system, engine oil and filter change intervals are extended beyond 250 hours. Refer to engine operation and maintenance manual for specific oil and filter change intervals. 2. If equipped, replace the engine oil filters. Follow the instructions of the filter manufacturer, which are normally printed on the outside of the filter. Do not use a wrench or strap to tighten filter elements. 3.

Check the tension and condition of each accessory drive belt. Refer to the engine operation and maintenance manual for specific adjustment instructions. 4. Check the torque on the cooling fan mounting capscrews. Tighten to 237 N•m (175 ft lbs). COOLING SYSTEM - 1. Check for proper coolant mixture. Add coolant as required. Refer to Cooling System Service on page 40-2. 2. Change the coolant filters. NOTE: Refer to the engine operation and maintenance manual for proper coolant mixture specifications and coolant filter replacement instructions. 3. Check the cooling system hoses for damage and deterioration. Replace as necessary. FUEL FILTERS - Change the Stage 1 and Stage 2 fuel filters.

Refer to engine Operation & Maintenance manual for specific filter replacement instructions.