OM4057 10/09 Lubrication and Service - Section 40 Page 40-9 250 HOUR LUBRICATION AND MAINTENANCE (Cont.) 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. TASK COMMENTS CHECKED INITIALS FUEL TANK - Drain water and sediment from the fuel tank. Refer to the shop manual for cleaning instructions. STEERING LINKAGE - 1. Check the torque on the steering pin retaining nuts. Tighten to 712 N•m (525 ft lbs). 2. Check the torque on the tie rod retaining nuts. Tighten to 420 N•m (310 ft lbs). HYDRAULIC PUMP DRIVESHAFT & U-JOINTS - Add one or two applications of grease to each grease fitting. Ensure that each bearing of the cross and bearing assembly is receiving grease. Replace bearings if any wear is detected.
(Lube Key D) REAR WHEEL MOUNTING - Use a flashlight and a mirror on a long rod to inspect all inner and outer wheel mounting nuts and studs. Check for loose, damaged or missing hardware. REAR AXLE HOUSING - Check the rear axle housing for oil leaks by removing the two drain plugs on the bottom of the axle housing. If oil is present, the cause of the leak must be found and corrected before operating the truck. FRONT WHEEL HUB - Remove the magnetic plugs from the front wheel hub covers and check for debris. Clean the plugs and perform any necessary repairs. MOTORIZED WHEELS - 1. Check for the correct oil level. There are eight oil level plugs.
Rotate the wheel so one plug is at the 6 o’clock position. The oil level should be even with the bottom of the plug opening. (Lube Key C) 2. Inspect the magnetic plugs for ferrous materials. Service the wheel motor as necessary. WHEEL MOTOR OIL SAMPLING - Take an oil sam- ple of the wheel motor oil. Refer to the shop manual for oil sampling instructions. BATTERIES - Check the electrolyte level and add water if necessary. BODY-UP AND HOIST LIMIT SWITCHES - Check the operation of the switches. Clean any dirt from the sensing areas and inspect the wiring for damage. CAB AIR FILTER - Clean the filter element with mild soap and water.
Rinse completely and dry with pressure air of 275 kPa (40 psi) maximum. Reinstall the filter.