Lubrication and Service - Section 40 10/09 OM4057 Page 40-12 1,000 HOURS LUBRICATION AND MAINTENANCE CHECKS All 10 Hour (Daily) Inspections, 250 Hour Lubrication and Maintenance Checks, and 500 Hour Lubrication and Maintenance Checks should also be performed at this time. NOTE: “Lube Key” references are to the Lubrication Chart on page 40-3. 1. 2. 3. 4 5. 6. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ 6. TASK COMMENTS CHECKED INITIALS HYDRAULIC TANK - Drain the hydraulic tank and clean the inlet strainers.
Refer to “Hydraulic Tank Strainers” in the shop manual. Refill the hydraulic tank. (Lube Key “B”) FUEL TANK - Remove the fuel tank breather and clean it in solvent. Dry the breather with pressurized air and install it on the tank. OPERATOR'S SEAT - Apply grease to the slide rails. (Lube Key “D”) AUTOMATIC BRAKE APPLICATION - Ensure that the brakes are automatically applied when the brake pressure decreases below the specified limit. Refer to Brake Circuit Check-Out Procedure, in the shop manual. MAIN BLOWER BEARINGS - On the main blower below the control cabinet, add one or two applications of grease to each bearing grease fitting. Ensure that each bearing is receiving grease.
Replace bearings if any wear is detected. (Lube Key F) GRID BLOWER MOTOR SHAFT BEARINGS - On each end of the electric motor, add one or two applications of grease to each bearing grease fitting. Ensure that each bearing is receiving grease. Replace bearings if any wear is detected. (Lube Key F)