Komatsu — SYSTEM OPERATION

Automatic Lubrication System - Section 42 OM4214 Page 42-4 SYSTEM OPERATION 1. During truck operation, the lubrication cycle timer will energize the system at a preset time interval. 6. When grease pressure reaches the setting of pressure switch (18, Figure 42-2), the switch contacts will close and energize the relay RB7- K8, removing power from the hydraulic motor/ pump solenoid so the pump will stop. The relay will remain energized until grease pressure drops (pressure switch opens again) and the timer turns off. 2.

The timer provides 24 VDC to energize pump solenoid valve (3, Figure 42-3), allowing hydraulic oil provided by the truck steering pump circuit to flow to the pump motor and initiate a pumping cycle. 7. After the pump solenoid valve is de-energized, hydraulic pressure in the manifold drops and vent valve (11, Figure 42-3) will open, releasing grease pressure in the lines to the injector banks. When this occurs, the injectors are then able to recharge for the next lubrication cycle. 3. The hydraulic oil from the steering circuit is directed through the pressure reducing valve (4) and flow control valve (6) before entering the motor.

Pump pressure can be read on optional pressure gauge (5) mounted on the manifold. 8. The system will remain at rest until the lubrication cycle timer turns on and initiates a new grease cycle. 4. With oil flowing into the hydraulic motor, the grease pump will operate, pumping grease from the reservoir to injectors (13), through check valve (10) and to vent valve (11). 9. During the normal lubrication cycle, if grease pressure fails to reach 13 790 kPa (2,000 psi) at the pressure switch located on the rear axle housing, an repair indicator light will illuminate on the monitor display panel. In addition, fault A190 “Auto Lube Fault” will be shown in the repair fault menu.. 5.

During this period, the injectors will meter the appropriate amount of grease to each lubrication point. FIGURE 42-3. HYDRAULIC SCHEMATIC 1. Hydraulic Oil Return 2. Hydraulic Oil Supply 3. Pump Solenoid Valve 4. Pressure Reducing Valve 5. Pipe Plug (Test Port) 6. Flow Control Valve 7. Hydraulic Motor 8. Grease Pump 9. Pressure Switch (N.O.) 10. Check Valve 11. Vent Valve 12. Orifice 13. Injector Bank 14. Unloader Valve