Payload Meter III - Section 60 OM6012 Page 60-10 K: New Tare Not Calculated The payload meter was not able to accurately calculate a new empty sprung weight for the truck to use as the tare value for the haul cycle. The tare value from the last haul cycle was used to calculate payload. Frame Torque Data Payload meter records the top five peak positive and negative frame torque values and the time they occurred. The frame torque is a measure of the twisting action along the centerline of the truck. Positive frame torque is measured when the suspension forces on the front of the truck act to twist the frame in the clockwise direction as viewed from the operator's seat.
Negative frame torque is measured when the forces from the suspensions act in the opposite direction. L: Incomplete Haul Cycle The payload meter did not have proper data to start the haul cycle with after powering up. When the PLMIII powers off, it records the data from the haul cycle in progress into memory. This flag indicates that this data was not recorded the last time the payload meter was shut down. This can happen when the main battery disconnect is used to shut the truck down instead of the key switch. A haul cycle with this warning flag should not be considered accurate.
Haul cycles with this warning are displayed in red on the Payload Summary window and are not included in the summary statistics for reports or display. For example, if the left front and right rear pressure rises as the right front and left rear pressure drops, the truck frame experiences a twisting motion along the longitudinal centerline. In this case, the payload meter will record a positive frame torque. The five highest values in the positive and negative direction are stored in permanent memory within the payload meter. Sprung Weight Data M: Haul Cycle Too Long The payload meter is constantly monitoring the live payload calculation.
This value naturally rises and falls for a loaded truck depending on road and driving conditions. The payload meter records the top five highest payload calculations and the time they occurred. This information is stored in permanent memory inside the meter. The haul_cycle_too_long flag indicates that the haul cycle took longer than 18.2 hours to complete. The times stored for particular events may not be accurate. This does not affect the payload calculation. N: Sensor Input Error An alarm was set for one of the five critical sensor inputs during the haul cycle. The five critical sensors are the four pressure sensors and the inclinometer.
Without these inputs, the payload meter cannot calculate payload. A haul cycle with this warning flag should not be considered accurate. Haul cycles with this warning are displayed in red on the Payload Summary window and are not included in the summary statistics for reports or display. Maximum Speed Data The payload meter records the top five highest speeds and the time they occurred. This information is stored in permanent memory inside the meter.