Yanmar — 5.Reassembly

Chapter 7 Reduction and Reversing Gear 1. Construction 3JH2 series Marine Gear Models KM3P1, KM3P3, KM35P1 for Engine Models 3JH25A /3JH30A 1. Construction 1-1. Construction As the damper disc is fitted to the input shaft, power can be transmitted smoothly. It is also anticorrosive against seawater. These clutches are a cone-type, mechanically operated clutch. When the drive cone (which is connected to the output shaft by the lead spline) is moved forward or backward, its taper contacts with the large gear and transfers power to the output shaft.

The construction is simple when compared with other- types of clutch and if serves to reduce the number of com- ponents, making for a lighter, more compact unit which can be operated smoothly. Although it is small, the power transmission efficiency is high even under a heavy load. Its durability is high and it is also reliable because high grade materials are used for the shaft and gear, and. a taper roller bearing is incorporated. Power transmission is smooth because connection There is small clearance between the dipstick and the inside of the dipstick tube. A small hole in the dipstick works as a breather.

when the load on the propeller is removed, the engage- ment of the drive cone and the large gear is maintained by the shifter and V-groove of the drive cone. Even when the drive cone's tapered area and V-groove are worn, this engagement is maintained by the shift lever device and accordingly no adjustment of the remote control cable is required. The cup spring on the rear of the larger gear absorbs rotational fluctuations and stabilizes the engagement of the drive cone and the larger gear. Thus, the durability of the cone against wear is enhanced. with the engine is made through the damper disc NOTE: KM3P3 marine gear differs from KM3P1 as follows.

The drive cone is made from special aluminum bronze, which has both higher wear-resistance and durability. The drive cone is connected with the output shaft through the thread spline. The taper angle, diameter of the drive cone, twist angle, and diameter of the thread spline, are designed to give the greatest efficiency, thus ensuring that the drive cone can be readily engaged or disengaged. Torque !imiter applied to KM3P3. KM35P1 marlne gear differs from KM3P1 as follows. Output shaft dia. 28mm. (KM3P1 : 25mm). Drive corn the same as the one for KM4A marine gear. Marine gear oil reserve capacity up. 0.5L (0.35L KM3P1 ) Helical gears are used for greater strength.

The intermediate shaft is supported at 2 points to reduce deflection and gear noise. The clutch ease and mounting flange are made from an aluminum alloy of special composition to reduce weight. Printed in Japan A0A1015-0302 Printed in Japan A0A1015-0302 7-29