. OPERATION OPERATION OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WARNING 4. Check for leakage from fuel line. Check that there is no leakage of fuel or damage to the hoses and tubes. If any problem is found, carry out repairs. bolts, or leakage of oil from 3 - 95 WALK-AROUND CHE CK Before starting the engin e, walk around the machine and look a t the underside of c hassis for anything u nusual l ike loose bolts and nuts, lea hydraulic system. kage of fuel, oil and coolant. Also check the condition of the work equipment and the ng, play, and collection of dust at places that reach high temperature.
the Also check for loose wiri ng, play, and collection of dust at plac es that reach high t emperatur Leakage of oil or fuel, or accumulation of flammable material arou nd high temperature p arts, such as the engin e muffle r or turbocharger, may cause fire. y abnormality is found, repair it or contact your Komatsu distributor. Check carefully, and if an y abnormality is found, repair it or contact your Komatsu distrib Do not get on or off the m achine from the rear. Using this position i s dangerous because it is easy to slip a nd yo u canno t be seen from the operator's compartment. Always use the handrail and step at the side whe n getting on or off the m achine.
Perform the following ins pections and cleaning every day befo re starting engine fo r the day' s work 1. Check for damage, w ear, play in work equipment, cylinder s, linkage, hoses Check that there are any abnormality is fo no cracks, excessive wear, or play in the work equipmen t, cylinder s, linkage, o r hose s. If und, repair it. 2. Remove dirt and dus t from around engine, battery radiator. Check if there is any d material (dead leave such as the engine m irt or dust accumulated around the en gine or radiator. Che ck also if t here i s any flammable s, twigs, grass, etc.) accumulated aro und the battery or high temperatu gine parts, uffler or turbocharger.
Remove all su ch dirt or flammable material. 3. Check for leakage of water or oil around engine Check that there is n is found, repair it. o oil leakage from the engine or coola nt leakage from the cooling s ystem . If an y problem 5. Check for oil leakage from power train case, final drive cas e, hydraulic tank, h ose, joint. Check that there is n Check for leakage of o oil leakage. If any problem is found, repair the place wh ere the oil is leaking. oil from the undercover. Check the gr ound for traces of o il leakage . 6.
Check the undercarr rollers If any damage, wear, If any damage, wear, or oil leakage is found, repair the pro blem and tighten th or oil leakage is found, repair the pro blem and tighten th