. OPERATION OPERATION OPERATION OPERATION Coolant temperature Turbo protect time (sec.) Above 10 ° C (50 ° F) 0 10 to -30 ° C (50 to -22 ° F) Change 0 to 20 below -30 ° C (-22 ° F) 20 3 - 122 6. When the engine starts, relea se the key i n starting switc The key w ill return automatic ally to the O N positio REMARK Immediately a fter starting the eng ine, run at i dle. Whi le running the engin e, release the decel erator pedal a nd do not operate th e work equipment. dle time er: At least 15 seconds er changing engine oil or engine oil filter: 20 seconds Guideline for i Cold weath er: At least 15 seco 1st start aft er changing engine oil or engin e oil filte r: 20 s econds 7.
When the engine rotation stab ilizes, return to the lo w idle (MIN) p osition of fuel control dial ( 1) and then car ry out the warmi ng-up operation. REMARK Regardless of the ambient tem perature, if t he key in the st arting s witch ( 2) is turned from the OFF position to the left, pre-he ating pilot la mp (3) will light up and pre-heating will start. (Pre-heating continues while the starting ) ime, see the table in Step 5. pre-heatin arting switch is be ing held to the left. For details of the pre-heating t ime, see the table in Step 5 During the pre-heating operatio n, pre-heati ng pilot la mp (3 ) lights up to sh ow that pre-heating is being carrie d out.
If the engin e does not start with the above operation, wait for at least 2 minutes, and repeat the procedure in d 4. Steps 3 an REMARK The turbo p rotect function is a function to protect th e turbocharg er. It k eeps the engine spe ed below 100 0 rpm for a set tim e after the engine is started ev en if the pedal is fully depressed. The basic f unction acts to can cel the actuation of t he turb o prote ct function when the engin e oil pressure rises. The setting s for the maximum actuation ti me are as show n below . Whe n the turbo protect f unction is actu ated, the engine speed does not ch ange even w hen the fuel co ntrol di al is m oved.