. OPERATION OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE WARNING BREAKING IN THE MACHINE 3 - 123 If there has been any Emergency stop, abno rmal actuation or trouble, turn the starti If the work equip ment is operated without su fficiently warming the machine up, respo nse of the work equipment to movement of the control lev er will be slow, and the wo rk equipment may not respond as the operator desires, so always perform the warming-up oper ation. Particularly in cold a reas, be sure the warming-up operation CHECKING OF ENGINE STARTABILITY AND NOISE When starting the engine, check that the e ngine causes no abnormal noise and that it starts up easily and smoothly.
Check also that th ere is no abnormal nois e when the engine is idling or when the revolution rises slightly. ition continues, the engine may be s soon as possible. When there is an abnormal noise at t he engine startup and if that cond damaged. In th at case, ask your Koma tsu distributor to check the engine a CHECKING OF ENGINE ACCELERATION AND DECELERATION When stopping the machine during the ope ration, check that there is no irregula r engine revolution or that the engine does not stop sud denly. e engine speed rises smoothly when the fuel control dial is turned to the full (Max). checks in a safe place, watching out for danger in the surroundings.
ne performs very badly at low idling and in the acceleration and if that condition continues, the Check also that th e engine speed rises s moothly when the fuel control dial is Carry out these checks in a safe place , watching out for danger in the surr When the engi ne performs very badly at low idling and in the acceleration the engine may be damaged or confuse the operator's sense of driving or lower t he braking efficiency, and as a result lead to an une possible. xpected accident. In that case, ask your Komatsu distributor to check the engine as soon as NOTICE Your Komatsu mach ine has been thoroughly adjusted and tested before shipment from the factory.
However, operating the machine under full l oad before breaking the ma chine in can adversely affect the perfor mance and shorten the machine life. Be sure to break in t he machine for the initial 1 00 hours (as indicated on the service me ter). Make sure that yo u fully understand the co ntent of this manual, and pay careful attention to the following points when breaking in the ma chine. Run the engine at idle for 15 seconds a fter starting it. During this time, do not operate the control levers or fuel control dial. for 5 minutes after starting it up. with heavy loads or at high speeds.
Idle the engine for 5 minutes after starti Avoid operation with heavy loads or at Immediately aft er starting the engine, av oid sudden starts, sudden accelerat ion, unnecessary sudden stops, and sudden change s in direction.