Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION WARMING UP OPERATIONS 3. Check for abnormal exhaust gas color, noise, or vibration. problem is found, contact your Komatsu distributor. 3 - 124 NOTICE Do not carry out operations w temperature, and do not operate hen the hydraulic oil is still at low the control levers suddenly. Always carry out the warming-up operati monitor shows the green dis on until the hydraulic oil temperature play. Performing the warming-up operation properly will extend the Do not suddenly accelerate the en is completed. service life of the machine. gine before the warming-up operation Do not run the engine under n continuously for more than 20 min o load at low idling or high idling utes.

This will have an adverse effect on the environment, and will also have an adverse effect on the internal structure of the turbocharger and engine. If it is necessary to run the engine at idling, apply a load fro m time to time or run at a mid-range speed. If the engine oil pressure monitor on machine monitor (2) flashes or the alarm buzzer sounds intermitten inspection. tly, stop the engine and carry out out 1. Turn fuel control dial (1) to t he center position between LOW I DLE (MIN) and HIGH IDL E (MAX) and run the engine at inutes with no load. medium speed for about 5 m 2. After it completing the war gauges and caution lamps ming-up operation, check that work properly.

If any problem all is f l ound, carry out maintenanc ight load until the engine w monitor (2) enters green ran e or repair. Run the engine under ater coolant gauge on machine ge (A) - (C). (A) - (B): Red range (A) - (C): Green range (C) - (D): White range If any