Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION (C) - (D): White range exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu 3 - 125 IN COLD AREAS RMING-UP OPERATION) uipped with an automatic warming-up device. ne is started, if the engine coolant temperature is low (below 30 °C (86 °F)), the warming-up ried out automatically. warming-up operation is canceled if the engine coolant temperature reaches the specified (AUTOMATIC WA This machine is eq uipped with an automati When the engi ne is started, if the engi operation is car ried out automatically. warming-up operation i T he automatic temperature (3 0 °C (86 °F)) or if the wa rming-up operation is continued for 10 minutes.

If the engine coolant temperature or hydraulic oil temperature are low after the automatic warming-up operation , warm the engine up further as follow s. 1. T urn fuel contr ol dial (1) to the center p osition between LOW I m DLE (MIN) a nd HIGH IDLE (MAX) a nd run the engine at th no load. edium speed for about 10 minutes wi 2. O perate blade control lever (4) to the RAISE position, then k r 3. F eep the blade raised to the maximum height and continue to elieve the circ inally, operat uit for 10 minutes. e blade control lever (4) a nd ripper control lever t If r e o operate the the oil temp aised, there quipment and blade and ripper cylinders several times.

erature in the work equipment is not properly will be a time lag in the response of the work steering. 4. A f C c r fter warm-up or proper ope is completed, check gau ration. If any problem is f ges and caution lamps ound, repair it. ight load until engine 2) is within the green ontinue to ru oolant tempe ngine green ange (A) - (C) (A) - (B): R (A) - (C): Gr REMARK I f the power train oi l temperature is not raise d sufficiently, it wi ll take long er to accelerat e to the maximum speed . 5. C heck for abn d istributor.