. OPERATION OPERATION to the OUT" removed the down will (F)Front of the machine 3. Move the ripper up or down to set to the desired shank position. REMARK Align mark of ripper (A) with top surface of holder (B). (C) (D) (E) Depth Max. Depth intermediate Depth min. 4. Operate the pin puller control switch to insert the mounting pin. If the pin does not match the position of the hole in the shank, set the pin puller control switch to the "PUSH IN" position (2) and slowly move the ripper up or down. REMARK When raising the pin position to increase the digging depth, use a long protector to prevent wear of the shank.
(F)Front of the machine 3 - 149 METHOD OF OPERATING PIN PULLER This operation i s used only when a giant r ipper i s installed 1. S top the safe place shan round. 2. Operate ller controller switch osition (1) and remove the mounting pin REMARK I f the mounting pin cannot be mov e th e ri pper slightl y up possible to r emove the pin. perating and tilt it. This switch, make it