Komatsu — OPERATING METHOD FOR RIPPING OPERATIONS

. OPERATION OPERATION OPERATION OPERATION REMARK (A)Length of track on ground RIPPING BY CLIFFS When carrying out ripping at the edge of a cliff, tilt the ripper back (B) to make depth (L) longer. Depress the decelerator pedal, drive slowly forward, and when the ripper point contacts the cliff, tilt the ripper in (A). RIPPING BY SLOPE FACES (Giant ripper) When carrying out ripping work at the edge of slope faces, make the ripper tilt back (B) angle small, and if there is an area where the slope face (1) has not been ripped, apply the ripper diagonally.

3 - 151 If the ripper is applied with the rear of t he machine r aised from the ground, the drawbar pul l will be low, so the rippin g efficiency will be reduced If t he ripping depth is unevenness, a nd this will operation. kept there will be no ncrease the efficiency of the dozing