Komatsu — OPERATING METHOD FOR RIPPING OPERATIONS

. OPERATION OPERATION OPERATION OPERATION tilted Do not change the direction of travel during the ripping operation. This will cause breakage of the shank. When changing the direction of travel, remove the shanks from the ground before turning. to travel over. If ripping operations are carried out with the shank at the maximum length on bedrock, the point will not penetrate the groundproperly. This will cause an increase in the load and may lead to breakage of the shank. For this reason, avoid carrying out operations on bedrock with the shank at the maximum length. 3 - 154 back (B). The tip of the poi nt will wear to a round shape.

Never drive in reverse wh en the ripper point is inserted in the bedrock. The pin installing the point (1) will break and th e point will fall off. Stop the machine, tilt bac slowly. k (B) slightly, then raise the ripper traveling over the ripping everse. When traveling in reverse heating any large rocks. As (3), check the rear carefully t far as possible, choose level o avoid ground