Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUSTING POSTURE OF WORK EQUIPMENT WARNING BLADE ADJUSTMENT TILTING THE TILTDOZER 3 - 155 When adjusting, it is d angerous if the work equipme nt is moved b y mistake. Set the work equipmen t in a safe condition, the n stop the engine and lock th e work equipment securely w ith the work equipment loc NOTICE The maximum tilt is 9 Adjust the tilt so that it does not exceed the limit of 935 mm (3 f t 1 in). If the maximum tilt is exceeded, excessive force wi ll be brought to be ar on all p arts, and this will When the blade co ntrol lever is operated, the following tilt can be 18.1 in) mm or more .1 in) or more have a greater tilt, do as follows.

fixed to the right brace to turn brace (1) and l ) of the brace to give a maximum tilt of 950 tance between the joints ( l ) is as follows. 372 mm lt can be obtained. Right tilt: 460 mm ( Left tilt: 460 mm (18 If it is necessary to have a greater tilt, do as f ollows Use bar handle (2) fixed to the right brace to turn brace change the length ( mm (3 ft 1 in). The standard dis tance between the joints ( l ) is as fol lows. Semi U-dozer: 1 ADJUSTING SHIM IN BLADE CYLINDER CAP Set the standard shi m adjustment in the blade cylinder cap to 4 mm (0.16 in). alance the wear of the cap and the ball at the d.

Remove shims to b alance the wear of the ca p and the b end of the piston ro The proper clearan ce to be maintained with th e shims is 0 .2 to 0.5 mm (0.008 to 0.02 i n).