. OPERATION OPERATION TIPS FOR LONGER UNDERCARRIAGE LIFE operation, keep the following point in mind. 3 - 162 inspection and maintena nce. For most efficient OPERATION METHOD suits the type of soil to be encountered in service. or when selecting track shoes. Select the track shoe that best Consult your Komatsu distribut or when selecting track shoes. Do not allow shoe slipage to oc cur during operation. If slipage occurs, reduce load to the bl ade until slipping stops. Avoid sudden starts, accelerat ion or stops, unnecessary high s peeds and sharp turns. When making turns, be c areful not to allow the Always operate machine in a straight line whenever possible.
machine to stay to one side, s largest possible radius. Prior to operation, clear boulde rs and obstacles to prevent machine from riding over the On a slope, operate the machin e parallel to the inclination of the slope. Do not operate across th e slope. Also when stopping the machine on a slope, the mac slope. When ground inclines to th operations, do not continue to hine should face the top of the e left or right during digging dig with the incline. Move the and start to dig again.
that are difficult to move during machine back to level ground If you come across obstacles dozing operations or ripper operations, and the idler or sprocket come up from the ground, it means that the operation is excessive for the machine, so avoid such operations. dozing operations or ripper ope rations, and the idler or sprocket come up from the ground, i excessive for the machine, so INSPECTION AND ADJUSTIN G at clearance (A) shown in the (0.8 to 1.2 in) at this point. For lightly. In clay or sandy areas, Properly adjust track tension. Tension should be measured diagram - usually 20 to 30 mm rocky terrain, tighten tracks s slightly loosen them.
(For inspection and adjustment procedures, refer to "CHECK A (PAGE 4-28)"). ND ADJUST TRACK TENSION Check idler rollers for oil leaka ge as well as for loose bolts and nuts. If any trouble is detected, repair immediately. Check clearance S between the idler guide plate and track frame. If clearance S becomes larger, the idler will move to the side and cause the track shoe to come off. For details of the method of inspection and mai ntenance, see "ADJUST IDLER CLEARANCE (PAGE 4-31)".